Components
COMPONENTS
ILLUSTRATION
*1 | BAGGAGE HOLDER NET |
*2 | LUGGAGE COMPARTMENT DOOR WEATHERSTRIP |
*3 | NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
*4 | REAR FLOOR FINISH PLATE |
*5 | SPARE WHEEL COVER ASSEMBLY |
- | - |
в—Џ | Non-reusable part |
- | - |
Installation
INSTALLATION
PROCEDURE
1. INSTALL LUGGAGE COMPARTMENT DOOR WEATHERSTRIP
(a) Make sure to remove any non-drying sealant from the installation surfaces on the vehicle body. NOTICE: If there is any non-drying sealant remaining on the vehicle body, the luggage compartment door weatherstrip may not be able to be securely installed and may fall off. Make sure to completely remove the non-drying sealant from both the interior side and exterior side installation surfaces on the vehicle body. |
|
(b) Align the joint of a new luggage compartment door weatherstrip with the luggage compartment door lock striker and temporarily install the luggage compartment door weatherstrip.
*a | Alignment Mark (Green) |
*b | Alignment Mark (White) |
*c | Joint |
- | - |
![]() |
Flange Position | - |
- |
(c) Align the alignment marks on the luggage compartment door weatherstrip with the flanges on the vehicle body indicated by the arrows, and install the luggage compartment door weatherstrip.
NOTICE:
HINT:
Make sure to install the parts of the luggage compartment door weatherstrip near the joint and alignment marks shown in the illustration first, and then install the corners.
2. INSTALL REAR FLOOR FINISH PLATE
Click here
3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
4. INSTALL BAGGAGE HOLDER NET
Click here
5. INSTALL SPARE WHEEL COVER ASSEMBLY
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE SPARE WHEEL COVER ASSEMBLY
Click here
2. REMOVE BAGGAGE HOLDER NET
Click here
3. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
4. REMOVE REAR FLOOR FINISH PLATE
Click here
5. REMOVE LUGGAGE COMPARTMENT DOOR WEATHERSTRIP
(a) Remove the luggage compartment door weatherstrip. |
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Steering Column: Steering System
Adjustment ADJUSTMENT PROCEDURE 1. STEERING WHEEL OFF CENTER ADJUSTMENT PROCEDURE (a) Inspect steering wheel off center. (1) Turn the steering wheel assembly to the center position. (2) Apply masking tape to the top center of the steering wheel assembly and upper steering column cover. *1 Steering W ...