Components
COMPONENTS
ILLUSTRATION
|
*1 | COWL SIDE TRIM SUB-ASSEMBLY LH |
*2 | FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
|
*3 | FRONT DOOR SCUFF PLATE LH |
*4 | HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
|
*5 | INSTRUMENT SIDE PANEL LH |
*6 | LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY |
|
*7 | NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
*8 | NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY
| (a) Check the switch. (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
2 - 5 | Pressed (On) |
Below 25 Ω | |
2 - 5 | Not pressed (Off) |
1 MΩ or higher | If the result is not as specified, replace the luggage compartment door opening switch assembly. |
 |
|
*a | Component without harness connected
(Luggage Compartment Door Opening Switch Assembly) | | |
(b) Check the switch illumination.
(1)
Apply auxiliary battery voltage to the switch connector and check that
the luggage compartment door opening switch assembly illuminates.
OK:
|
Auxiliary Battery Connection |
Specified Condition |
|
Auxiliary battery positive (+) → Terminal 6 Auxiliary battery negative (-) → Terminal 1 |
Illumination illuminates |
If the result is not as specified, replace the luggage compartment door opening switch assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY
(a) Engage the 2 claws to install the luggage compartment door opening switch assembly as shown in the illustration.
 |
Install in this Direction |
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here 
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL INSTRUMENT SIDE PANEL LH
Click here
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here 
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
4. REMOVE INSTRUMENT SIDE PANEL LH
Click here
5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here
8. REMOVE LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY
(a) Disengage the 2 claws and remove the luggage compartment door opening switch assembly as shown in the illustration.
 |
Remove in this Direction |
