Toyota Avalon (XX50): Luggage Compartment Door Opener Outer Switch

Components

COMPONENTS

ILLUSTRATION

LUGGAGE ELECTRICAL KEY SWITCH

Inspection

INSPECTION

PROCEDURE

1. INSPECT LUGGAGE ELECTRICAL KEY SWITCH

(a) Check the switch.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	Pressed (On)	Below 1 Ω
1 - 2	Not pressed (Off)	10 kΩ or higher

If the result is not as specified, replace the luggage electrical key switch.

*a	Component without harness connected (Luggage Electrical Key Switch)

Installation

INSTALLATION

PROCEDURE

1. INSTALL LUGGAGE ELECTRICAL KEY SWITCH

(a) Engage the 2 claws to install the luggage electrical key switch.

(b) Install the 2 screws.

(d) Connect the connector.

2. INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Click here

Removal

REMOVAL

PROCEDURE

1. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Click here

2. REMOVE LUGGAGE ELECTRICAL KEY SWITCH

(a) Disconnect the connector.

(b) Disengage the clamp.

(d) Disengage the 2 claws to remove the luggage electrical key switch.

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Can Communication System(for Gasoline Model): Radio Receiver Assembly Communication Stop Mode. Rear Television Camera Communication Stop Mode. Restraints Occupant Classification System Module Communication Stop Mode
Radio Receiver Assembly Communication Stop Mode DESCRIPTION Detection Item Symptom Trouble Area Radio Receiver Assembly Communication Stop Mode Any of the following conditions are met: Communication stop for "Display and Navigation (AVN)" is indicated on the "Communication Bus Check" screen of the T ...