Components
COMPONENTS
ILLUSTRATION
|
*A | for Driver Side |
*B | for Front Passenger Side |
|
*1 | COURTESY LIGHT ASSEMBLY |
*2 | FRONT DOOR ARMREST COVER SUB-ASSEMBLY |
|
*3 | FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
*4 | FRONT DOOR TRIM POCKET COVER |
|
*5 | MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL |
*6 | OUTER MIRROR CONTROL ECU ASSEMBLY |
|
*7 | POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL |
- | - |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY
(a) Connect the 2 connectors.
(b) Install the outer mirror control ECU assembly with the 2 screws.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
3. INSTALL COURTESY LIGHT ASSEMBLY
Click here
4. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
6. INSTALL FRONT DOOR TRIM POCKET COVER
Click here
7. INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY
Click here
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY
Click here 
2. REMOVE FRONT DOOR TRIM POCKET COVER
Click here
3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
Click here
4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
Click here
5. REMOVE COURTESY LIGHT ASSEMBLY
Click here
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
Click here
7. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY
| (a) Remove the 2 screws. |
|
(b) Disconnect the 2 connectors to remove the outer mirror control ECU assembly.
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Front Speed Sensor RH Circuit Output (C1413,C1414)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. HINT: The output voltage values shown below are for when the vehicle wire harnesses are connected to the skid con ...
