Components
COMPONENTS
ILLUSTRATION
|
*1 | COWL SIDE TRIM SUB-ASSEMBLY LH |
*2 | FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
|
*3 | FRONT DOOR SCUFF PLATE LH |
*4 | FUEL LID OPENER SWITCH |
|
*5 | HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
*6 | INSTRUMENT SIDE PANEL LH |
|
*7 | NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY |
*8 | NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL LID OPENER SWITCH
| (a) Check the switch. (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
2 - 5 | Pressed (On) |
Below 1 Ω | |
2 - 5 | Not pressed (Off) |
10 kΩ or higher | If the result is not as specified, replace the fuel lid opener switch. |
 |
|
*a | Component without harness connected
(Fuel Lid Opener Switch) | | |
(b) Check the switch illumination.
(1) Apply auxiliary battery voltage to the switch connector and check that the fuel lid opener switch illuminates.
OK:
|
Auxiliary Battery Condition |
Specified Condition |
|
Auxiliary battery positive (+) → Terminal 6 Auxiliary battery negative (-) → Terminal 1 |
Illumination illuminates |
If the result is not as specified, replace the fuel lid opener switch.
Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL LID OPENER SWITCH
(a) Engage the 2 claws to install the fuel lid opener switch as shown in the illustration.
 |
Install in this Direction |
2. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here 
3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
5. INSTALL INSTRUMENT SIDE PANEL LH
Click here
6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
8. INSTALL FRONT DOOR SCUFF PLATE LH
Click here
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here 
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Click here
4. REMOVE INSTRUMENT SIDE PANEL LH
Click here
5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
6. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Click here
7. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY
Click here
8. REMOVE FUEL LID OPENER SWITCH
(a) Disengage the 2 claws and remove the fuel lid opener switch as shown in the illustration.
 |
Remove in this Direction |
